Combo Kit - Stretcher and Boring Jig

$400.00



This Combo Kit includes both the Stretcher Jig and Barton Boring Jig. These Jigs allows you to easily drill holes in chair legs for stretchers, and in chair back posts for arm rests, from 6" to 22" from the seat; and easily drill holes in chair seat blanks for leg, arm post and spindle mortises. You can see it in action on my YouTube channel https://www.youtube.com/user/thetexwood.

These Jigs require a drill capable of accepting 1/2" shank drill bits; and a 1/2" shank brad-point bit with a long center-spur to work correctly for acute angles (Trident Drill Bit). This Kit should work fine if you are already using these types of "chairmaking" bits with a 1/2" shank.

The Stretcher Jig kit includes the following:
Large Base Unit
Small Base Unit
Four Threaded Rods with two jam nuts per rod
Center-Finder
1/2" Drill extension shaft - 18" Long
1/2" Coupler - To connect the shaft to your 1/2" shank drill bit
1/2" Bearing

Please Note: The Stretcher Jig is made for a 6 degree reamed holes. Please contact me if you use a different reamer; I should be able to accommodate you.

The Barton Boring Jig kit includes the following:
Barton Boring Jig
Set-Up Block/Angle Gauge
Threaded Rod with 5 jam nuts
1/2" Drill extension shaft - 10" Long
1/2" Coupler - To connect the shaft to the 1/2" shank drill bits
1/2" Rod End Bearing

Legal imprint